中文字幕二区-52影院-国产探花视频在线观看-欧美 日韩 人妻 高清 中文-三上悠亚ssⅰn939无码播放-扒开美女狂揉下部-亚洲第一黄-aaaaa级片-亚洲男人的天堂在线观看-亚洲中文字幕无码爆乳av-天天艹天天射-波多野结衣电车-日韩一级特黄-久久高清av-吴家丽查理三级做爰-日本亚洲一区二区三区-手机看片1024在线-欧美另类自拍-波多野结衣在线影院-揉我胸啊嗯~出水了古代视频-粉色午夜视频-操大奶子美女-久久高清免费-色免费看-国产ts一区二区-亚洲 中文字幕 日韩 无码-国产精品 欧美 日韩-日本亲与子乱ay中文-秋霞午夜片-亚洲日本欧美在线

Products

PRODUCT CENTER

HongJin-6610 two-component 10:1 silicone encapsulant

6610.jpg



Brief introduction


modelHongJin-6610
Specification50ml/branch
characteristicHongJin-6610 is a two-component 10:1 silicone potting compound with high transparency, medium elasticity, good insulation performance, flex resistance, oxidation resistance, good heat dissipation, high and low temperature resistance (under -60 ℃ ~ 200 ℃) Long-term use), good performance, no whitening, long life, maintenance-free, anti-oxidation, anti-yellowing, stable chemical and physical properties, and superior UV resistance.
Applicable ProductsIt is widely used in potting and coating of LED lamps, electronic appliances, circuit boards and other products. Especially suitable for waterproof protection of LED strips.


Technical parameter



technical parameter

Acomponent

Bcomponent

Before curing

Exterior

light blue fluid

Platinum Fluid

Viscosity(cps)

1000~2000

50~150

The mixing ratioA:B(weight ratio)

10:1

Viscosity after mixing(cps)

800~1600

Dry time(min)

30~60

curing time(h)

2~4Initial cure in hours, full cure in 24 hours, peak strength in 7 days

After curing

hardness(ShaoA)

10~20

Shear strength,Mpa

≥0.5

Tensile Strength,Mpa

≥0.8

Dielectric strength(KV/mm)

≥13

Dielectric constant(1.0MHz)

2.5~3.3

Volume resistivity(Ω·cm)

≥1.0×1015


Precautions


1、The rubber compound should be sealed and stored in a cool and ventilated place below 30℃. The mixed rubber should be used up at one time to avoid waste. 

2、This product is non-dangerous, but keep out of mouth and eyes.

3、Weighing: accurately weigh components A and B (A:B=10:1);

4、Stirring: After the two components are mixed, stir well, about 1-2min

5、Spray coating: The spray coating is subject to no leakage or sagging. The thickness of a coating film is generally between 0.1-0.3mm

5、Curing: keep the environment at 25±10℃, 55±20%RH.

Copyright ? 2020 深圳市宏進科技有限公司All Rights Reserved  粵ICP備20066503

0755-28307837

scan it
Pay attention to the public account

Scan and pay attention to the public number